900 Fluor Films Product Data Sheet
Introduction
Avery® 900 Fluor Films increase the attention value of safety applications and advertising messages.
Description
- Facefilm: 110 micron, premium quality two layer fluorescent cast vinyl
- Adhesive: permanent, acrylic based
- Backing paper: one side coated bleached kraft paper, 140 g/m©˜
Features
- Bright colours that provide excellent conspicuity.
- Excellent adhesion to a wide variety of substrates.
- Excellent dimensional stability.
- Avery 900-3 Fluor Red complies with European specifications for use on:
- Rear Vehicle Markings
- Advance Warning Triangles
- Slow Moving Vehicle Markings
Recommendations for use
- In traffic and transport wherever safety, visibility and high conspicuity are required.
- Eye catching aid to promotional displays.
PRODUCT CHARACTERISTICS Avery® 900 Fluor Films
Physical properties
Features Test method1 Results
- Caliper, facefilm ISO 534 110 micron
- Dimensional stability DIN 30646 0,3 mm. max
- Adhesion, initial FINAT FTM-1, stainless steel 600 N/m
- Adhesion, ultimate FINAT FTM-1, stainless steel 800 N/m
- Shelf life Stored at 22° C/50-55 % RH 2 years
Durability2 Vertical exposure
- 900-3 Fluor Red up to 18 months
- 900-2 Fluor Yellow up to 6 months
Note: Horizontal applications are not recommended. In such case the durability may significantly be decreased.
Temperature range
Features Results
- Application temperature Minimum: +10° C
- Temperature range -30° to + 110°C
Chemical resistance
Features Test method1 Results
- Humidity resistance 120 hours exposure No effect
- Water resistance 120 hours immersion No effect
- Gasoline resistance 2 hours immersion
- Appearance No change
- Adhesion No change
- Colour No change
- Solvent resistance Applied to aluminium, exposed to No effect oils, greases, aliphatic solvents,motor oils, heptane, kerosene and JP-4 fuel.
Important
Information on physical and chemical characteristics is based upon tests we believe to be reliable. The values listed herein are typical values and are not for use in specifications. They are intended only as a source of information and are given without guarantee and do not constitute a warranty. Purchasers should independently determine, prior to use, the suitability of this material to their specific use. All technical data are subject to change.
Warranty
Avery® branded materials are manufactured under careful quality control and are warranted to be free from defect in material and workmanship. Any material shown to our satisfaction to be defective at the time of sale will be replaced without charge. Our aggregate liability to the purchaser shall in no circumstances exceed the cost of the defective materials supplied. No salesman, representative or agent is authorised to give any guarantee, warranty, or make any representation contrary to the foregoing.
All Avery® branded materials are sold subject to the above conditions, being part of our standard conditions of sale, a copy of which is available on request.
- Test methods
More information about our test methods can be found on our website. - Durability
The durability is based on middle European exposure conditions. Actual performance life will depend on substrate preparation, exposure conditions and maintenance of the marking. For instance, in the case of signs facing south; in areas of long high temperature exposure such as southern European countries; in industrially polluted areas or high altitudes, exterior performance will be decreased.
